What is the first step to run a System Health check on a specific Metro Node system in Unisphere?

Click 'Run Health Check' on the toolbar without any selection

Select the Metro Node system from the system list

Open the 'System Health' page directly from the dashboard

Navigate to the 'Alerts' page and click 'Health Check'

What is the primary purpose of the System Health check in Unisphere for Dell Metro Node?

To collect performance metrics for capacity planning

To provide a comprehensive assessment of the Metro Node system's overall health and identify potential issues

To automatically apply firmware updates to all Metro Node directors

To replace the need for regular log monitoring and manual inspections

Which of the following components is evaluated during the System Health check in Unisphere for Dell Metro Node?

Director connectivity and status

Network switch firmware versions

Front-end host application performance

A Metro Node cluster has two directors in the same fault domain. The System Health check reports an error on Director 2: 'Peer Director Communication Lost'. The administrator checks the network and finds that the inter-director link is down. The cluster is still serving I/O, but the administrator is concerned about the risk. What is the most appropriate immediate action?

Place Director 2 in maintenance mode and schedule a replacement of the director.

Fail over all virtual volumes to Director 1 and continue operations on a single director.

Reboot Director 2 to re-establish the peer communication link.

Investigate and restore the inter-director link, then re-run the System Health check to confirm the error is cleared.

A new administrator needs to run a System Health check on a Dell Metro Node system. They have opened Unisphere and are logged in with an account that has the 'Storage Administrator' role. Where should they navigate to initiate the health check?

Go to the 'Storage' tab, select 'Pools', and click 'Validate Configuration'.

Go to the 'Services' tab, select 'Support', and click 'Generate Health Report'.

Go to the 'System' tab, select 'Maintenance', and click 'Start Diagnostics'.

Go to the 'Monitor' tab, select 'Health', and click 'Run System Health Check'.

Dell Metro Node Operate

Domain 1Objective 1

Perform and Analyze System Health Check with Unisphere METRO-NODE-OPERATE Practice Questions (Page 4)

Part of the Metro Node System Health domain, which accounts for 10% of the METRO-NODE-OPERATE exam.

25questions here

5free pages

5concepts

10%of the exam

Questions 16–20

16foundation · easy
What is the first step to run a System Health check on a specific Metro Node system in Unisphere?
Select an answer first
17foundation · easy
What is the primary purpose of the System Health check in Unisphere for Dell Metro Node?
Select an answer first
18foundation · easy
Which of the following components is evaluated during the System Health check in Unisphere for Dell Metro Node?
Select an answer first
19expert · hard
A Metro Node cluster has two directors in the same fault domain. The System Health check reports an error on Director 2: 'Peer Director Communication Lost'. The administrator checks the network and finds that the inter-director link is down. The cluster is still serving I/O, but the administrator is concerned about the risk. What is the most appropriate immediate action?
Select an answer first
20application · easy
A new administrator needs to run a System Health check on a Dell Metro Node system. They have opened Unisphere and are logged in with an account that has the 'Storage Administrator' role. Where should they navigate to initiate the health check?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to METRO-NODE-OPERATE

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “METRO-NODE-OPERATE” is a trademark of its owner, used for identification only.