EIGRP CCIE-ENTERPRISE-INFRASTRUCTURE Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   In EIGRP, what is the primary criterion for a route to be selected as the successor?

   • AThe route with the lowest feasible distance (FD) to the destination
   • BThe route with the lowest hop count
   • CThe route with the lowest advertised distance (AD)
   • DThe route with the highest bandwidth and lowest delay
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   Which condition must a route satisfy to be considered a feasible successor in EIGRP?

   • AIts advertised distance (AD) must be less than the feasible distance (FD) of the successor
   • BIts feasible distance (FD) must be less than the advertised distance (AD) of the successor
   • CIts advertised distance (AD) must be equal to the feasible distance (FD) of the successor
   • DIts feasible distance (FD) must be equal to the advertised distance (AD) of the successor
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   What is the role of a feasible successor in EIGRP?

   • AIt is a route that is advertised to neighbors but not installed in the routing table
   • BIt is a backup route that is used immediately if the successor fails, without recomputing the topology
   • CIt is a route that is used only when the network converges after a topology change
   • DIt is the primary route used to forward traffic to the destination
   Reveal Solution Discussion Select an answer first
5. 4application · medium

   A network engineer is troubleshooting an EIGRP neighbor adjacency that flaps every 60 seconds. The engineer notices that the hold time on the neighbor is set to 15 seconds, but the hello timer on the local router is set to 5 seconds. The link is a high-latency satellite link with 800 ms delay. What should the engineer do to stabilize the adjacency?

   • AIncrease the hold time on the local router to 20 seconds.
   • BSet the hello timer to 10 seconds and the hold time to 30 seconds.
   • CIncrease the hello timer on the local router to 20 seconds.
   • DDisable the EIGRP neighbor adjacency on the satellite link and use a static route.
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   An engineer is configuring EIGRP named mode on a router. The engineer wants to set different hello and hold timers on a specific interface, and also enable unequal-cost load balancing for the entire address-family. What is the correct configuration approach?

   • AConfigure the timers under the address-family configuration, and the variance under the interface configuration.
   • BConfigure the timers under the interface configuration, and the variance under the address-family configuration.
   • CConfigure both timers and variance under the interface configuration.
   • DConfigure both timers and variance under the address-family configuration.
   Reveal Solution Discussion Select an answer first