CiscoCertified Network Professional Data Center
Domain 1Objective 3
1.3 Apply Overlay Protocols Such as VXLAN EVPN 350-601 Practice Questions (Page 3)
Part of the Network domain, which accounts for 25% of the 350-601 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~13–20 in this domain), expect 1–2 from this objective — we provide 25 practice questions to prepare you well beyond it. (estimate)
25questions here
5free pages
5concepts
25%of the exam
Questions 11–15
- 11
A network engineer is troubleshooting a VXLAN EVPN issue where a host on leaf1 cannot communicate with a host on leaf2 in the same VNI. The engineer checks 'show nve peers' on leaf1 and sees the remote VTEP is listed. The engineer also checks 'show bgp l2vpn evpn' and sees the remote MAC address is present. What should the engineer check next?
Select an answer first - 12
In VXLAN EVPN, which protocol is used to distribute MAC address and VTEP reachability information between VTEPs?
Select an answer first - 13
A network architect is designing a VXLAN EVPN fabric with a requirement to support both IPv4 and IPv6 tenants. The underlay is IPv4-only. How can the fabric support IPv6 tenant traffic?
Select an answer first - 14
An engineer is configuring VXLAN EVPN on a Nexus switch. They have configured the loopback interface, NVE interface, and VNI. What is the final step to enable the BGP EVPN control plane?
Select an answer first - 15
An engineer is verifying VXLAN EVPN operation on a Nexus switch. They need to confirm that the BGP EVPN session with the route reflector is established. Which command should they use?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “350-601” is a trademark of its owner, used for identification only.