
CiscoCertified Network Professional Enterprise
Domain 2Objective 2
2.2 Configure and Verify Data Path Virtualization Technologies 350-401 Practice Questions (Page 3)
Part of the 2.0 Virtualization domain, which accounts for 10% of the 350-401 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~5–8 in this domain), expect 2–3 from this objective — we provide 34 practice questions to prepare you well beyond it. (estimate)
34questions here
7free pages
8concepts
10%of the exam
Questions 11–15
- 11
What is the primary reason for using GRE over IPsec instead of IPsec alone?
Select an answer first - 12
A site-to-site IPsec VPN is configured with a crypto map on the outside interface. The tunnel does not come up. Which command should you use to verify the IKE phase 1 status?
Select an answer first - 13
Which IPsec protocol provides data confidentiality by encrypting the payload?
Select an answer first - 14
A network engineer is configuring a new VRF on a Cisco IOS XE router. The engineer creates the VRF, assigns an interface to it, and then configures a static route in the VRF. However, the route does not appear in the VRF's routing table. What is the most likely cause?
Select an answer first - 15
What is the role of IKE (Internet Key Exchange) in an IPsec VPN?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “350-401” is a trademark of its owner, used for identification only.