A network engineer is configuring a trunk link between two switches. The engineer wants to ensure that frames from VLAN 10 are sent untagged on the trunk, while all other VLANs are tagged. Which configuration should be applied?

Set the native VLAN to 10 on both ends of the trunk.

Disable 802.1Q tagging on the trunk.

Set the trunk port to access mode.

Configure VLAN 10 as the only allowed VLAN on the trunk.

A network administrator is configuring a trunk link between two switches. The administrator wants to ensure that all VLANs are allowed on the trunk, but also wants to prevent VLAN 1 from being used for user traffic. What should the administrator do?

Change the native VLAN to a different VLAN.

Remove VLAN 1 from the allowed VLAN list on the trunk.

What is the purpose of 802.1Q tagging on a trunk link?

To encrypt frames traveling over the trunk

To prioritize frames based on MAC address

To compress frames to increase throughput

To identify which VLAN a frame belongs to

When a switch receives a frame with a destination MAC address that is not in its MAC address table, what does the switch do?

It sends the frame to the router for forwarding

It floods the frame out of all ports in the same VLAN except the port it arrived on

It broadcasts the frame to all ports in all VLANs

CiscoCertified Network Associate Automation (CCNA Automation)

Domain 6Objective 1

1. Describe the Purpose and Usage of MAC Addresses and VLANs 200-901 Practice Questions (Page 3)

Part of the 6.0 Network Fundamentals domain, which accounts for 15% of the 200-901 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~8–12 in this domain), expect 1–1 from this objective — we provide 38 practice questions to prepare you well beyond it. (estimate)

38questions here

8free pages

7concepts

15%of the exam

Questions 11–15

11application · easy
A network administrator is configuring a new switch for a branch office. The administrator needs to create a VLAN for network management traffic that will be used to manage the switch remotely. Which VLAN type should be used for this purpose?
Select an answer first
12application · medium
A network engineer is configuring a trunk link between two switches. The engineer wants to ensure that frames from VLAN 10 are sent untagged on the trunk, while all other VLANs are tagged. Which configuration should be applied?
Select an answer first
13expert · medium
A network administrator is configuring a trunk link between two switches. The administrator wants to ensure that all VLANs are allowed on the trunk, but also wants to prevent VLAN 1 from being used for user traffic. What should the administrator do?
Select an answer first
14foundation · easy
What is the purpose of 802.1Q tagging on a trunk link?
Select an answer first
15foundation · easy
When a switch receives a frame with a destination MAC address that is not in its MAC address table, what does the switch do?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to 200-901

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “200-901” is a trademark of its owner, used for identification only.