A junior administrator is able to enter global configuration mode but cannot run 'show running-config'. The administrator's user account is assigned privilege level 5. What is the most likely reason for this?

The administrator is not in enable mode.

The 'show running-config' command is restricted to privilege level 15.

The administrator needs to use 'show config' instead.

The command is not available in the IOS version.

A network engineer is troubleshooting a single interface that is dropping packets. The engineer wants to see detailed statistics for only that interface, including input/output errors and collisions. Which command should be used?

show interfaces gigabitethernet 0/1

A junior administrator is asked to verify whether a specific interface has been configured with a particular IP address and subnet mask. The administrator is in privileged EXEC mode. Which command will display the current running configuration for that interface?

show interface GigabitEthernet0/1

show running-config interface GigabitEthernet0/1

What is the purpose of privilege levels on a Cisco device?

To set the IP address of an interface

To control which commands a user can execute

To determine the speed of the interfaces

A network technician is troubleshooting intermittent connectivity on a single switch port. The technician needs to see detailed statistics for that port, including input/output errors, collisions, and CRC errors. Which command should be used?

show interfaces GigabitEthernet0/1

CiscoCertified Support Technician (CCST) Networking

Domain 5Objective 5

5.5. Run Basic Show Commands on a Cisco Network Device. 100-150 Practice Questions (Page 4)

Part of the Diagnosing Problems domain, which makes up ~21% of our current practice bank. Cisco does not publish an official question count, but from its 50-minute exam (~20–35 total, ~4–7 in this domain), expect 1–1 from this objective — we provide 26 practice questions to prepare you well beyond it. (estimate)

26questions here

6free pages

13concepts

Questions 16–20

16application · medium
A junior administrator is able to enter global configuration mode but cannot run 'show running-config'. The administrator's user account is assigned privilege level 5. What is the most likely reason for this?
Select an answer first
17application · medium
A network engineer is troubleshooting a single interface that is dropping packets. The engineer wants to see detailed statistics for only that interface, including input/output errors and collisions. Which command should be used?
Select an answer first
18application · medium
A junior administrator is asked to verify whether a specific interface has been configured with a particular IP address and subnet mask. The administrator is in privileged EXEC mode. Which command will display the current running configuration for that interface?
Select an answer first
19foundation · easy
What is the purpose of privilege levels on a Cisco device?
Select an answer first
20application · medium
A network technician is troubleshooting intermittent connectivity on a single switch port. The technician needs to see detailed statistics for that port, including input/output errors, collisions, and CRC errors. Which command should be used?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to 100-150

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “100-150” is a trademark of its owner, used for identification only.