CiscoCertified Support Technician (CCST) Networking
Domain 5Objective 5
5.5. Run Basic Show Commands on a Cisco Network Device. 100-150 Practice Questions (Page 1)
Part of the Diagnosing Problems domain, which makes up ~21% of our current practice bank. Cisco does not publish an official question count, but from its 50-minute exam (~20–35 total, ~4–7 in this domain), expect 1–1 from this objective — we provide 26 practice questions to prepare you well beyond it. (estimate)
26questions here
6free pages
13concepts
Questions 1–5
- 1
A network administrator wants to see which MAC addresses are learned on which switch ports. Which command displays the MAC address table?
Select an answer first - 2
A network engineer is troubleshooting intermittent connectivity on a switch. The engineer suspects a faulty cable on one port. Which command would provide the most detailed information about errors on that specific port?
Select an answer first - 3
Which command would you use to check the error counters on the FastEthernet0/0 interface of a Cisco router?
Select an answer first - 4
A network administrator wants to see a list of directly connected Cisco devices and their device identifiers. Which command provides this information?
Select an answer first - 5
A network administrator needs to view the current configuration that is actively running on a Cisco switch. Which command displays this information?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “100-150” is a trademark of its owner, used for identification only.