Use the Timechart Command SPLK-1002 Practice Questions (Page 4)

Questions 16–19

1. 16foundation · easy

   What is the primary purpose of the timechart command in Splunk?

   • ATo summarize data into a table with rows representing distinct values of a field.
   • BTo create a time-series chart where the x-axis is always _time and the y-axis shows aggregated values.
   • CTo display raw events in chronological order without any aggregation.
   • DTo create a chart where the x-axis is any field you specify and the y-axis is the count of events.
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   Which timechart function would you use to calculate the average value of a numeric field over each time bucket?

   • Amax
   • Bcount
   • Csum
   • Davg
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   What is the minimum required component in a timechart command?

   • AA custom time span to set the bucket size.
   • BA field to use as the x-axis.
   • CA statistical function applied to a field or the special value count.
   • DA BY clause to split the series.
   Reveal Solution Discussion Select an answer first
5. 19foundation · easy

   What is the purpose of the BY clause in a timechart command?

   • ATo specify the time span for the buckets.
   • BTo split the time series into separate series for each value of a specified field.
   • CTo rename the output column for the aggregated value.
   • DTo filter events based on a field's value before aggregation.
   Reveal Solution Discussion Select an answer first