1.5 Configure, Implement, and Deploy Prisma Access for Remote Networks SECURITY-SERVICE-EDGE-ENGINEER Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   In which deployment model do all remote network sites connect to a central hub, which then connects to Prisma Access?

   • AMesh
   • BPoint-to-point
   • CHub-and-spoke
   • DStar
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   When designing a Prisma Access remote network deployment, which factor is most important to consider for optimal performance?

   • AGeographic location of the remote network gateways
   • BType of authentication used
   • CNumber of security policies
   • DColor of the IPsec tunnel
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which deployment model for remote networks provides direct connectivity between all sites, eliminating the need for a central hub?

   • AMesh
   • BTree
   • CRing
   • DHub-and-spoke
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A retail chain has 200 stores, each with a lightweight router that supports IPsec but not BGP. They want to connect all stores to Prisma Access with minimal configuration on each router. Which routing method should they use for the remote network connections?

   • ABGP on each router to exchange routes with Prisma Access
   • BOSPF on each router to advertise routes to Prisma Access
   • CStatic routes on each router pointing to Prisma Access, and static routes on Prisma Access for each store's subnet
   • DPolicy-based routing on each router to send all traffic to Prisma Access
   Reveal Solution Discussion Select an answer first
6. 10expert · hard

   A multinational company is deploying Prisma Access for remote networks. They have branch offices in North America, Europe, and Asia. They want to ensure that traffic from each branch is inspected by a Prisma Access location that is geographically close to the branch to minimize latency. What should they consider when configuring the remote networks?

   • APrisma Access automatically selects the closest location based on the branch's IP address
   • BAll remote networks should connect to a single Prisma Access location to simplify management
   • CThe branch must use BGP to allow Prisma Access to route traffic to the closest location
   • DEach remote network must be associated with a specific Prisma Access location, and the branch should connect to that location
   Reveal Solution Discussion Select an answer first