A branch office has a single LAN segment for all users, but the administrator needs to separate guest Wi-Fi traffic from corporate traffic. The switch supports VLAN tagging. Which configuration should the administrator implement on the Prisma SD-WAN branch device?

Configure the LAN interface as a trunk port and assign it to the corporate VLAN only

Create a single VLAN interface and use DHCP reservations to separate traffic

Use the same VLAN but apply a security policy to block guest access to corporate resources

Create two VLAN interfaces and assign different subnets to each

A company has two WAN links at a branch: a high-bandwidth fiber link and a lower-bandwidth LTE link. The administrator wants real-time voice traffic to always use the fiber link, while bulk file transfers can use either link. Which configuration should be used?

Configure a path selection policy that pins voice traffic to the fiber link and allows file transfers to use any link

Configure BGP to advertise the fiber link as the only path for all traffic

Use QoS to prioritize voice traffic on both links equally

Set the LTE link as the primary and the fiber link as backup

An organization wants to ensure that all traffic from branch users to the internet is inspected for threats, while traffic to the corporate data center over MPLS is not inspected to reduce latency. Which approach should the administrator take in Prisma SD-WAN?

Configure the firewall to inspect all traffic but disable logging for data center traffic

Create a security policy that applies threat prevention to all traffic, regardless of destination

Use a single security policy that only inspects traffic on the MPLS link

Create two security policies: one for internet-bound traffic with threat prevention, and one for data center traffic with no inspection

What is the first step in the initial configuration of Prisma SD-WAN when onboarding a new branch site?

Create the site in the controller

Assign IP addresses to LAN interfaces

Palo Alto NetworksCertified SD-WAN Engineer

Domain 2Objective 1

2.1 Explain Prisma SD-WAN Deployment and Configuration SD-WAN-ENGINEER Practice Questions (Page 3)

Part of the Deployment and Configuration domain, which accounts for 24% of the SD-WAN-ENGINEER exam.

28questions here

6free pages

8concepts

24%of the exam

Questions 11–15

11foundation · easy
Which QoS technique in Prisma SD-WAN is used to ensure that a specific application does not exceed a defined bandwidth limit?
Select an answer first
12application · medium
A branch office has a single LAN segment for all users, but the administrator needs to separate guest Wi-Fi traffic from corporate traffic. The switch supports VLAN tagging. Which configuration should the administrator implement on the Prisma SD-WAN branch device?
Select an answer first
13application · medium
A company has two WAN links at a branch: a high-bandwidth fiber link and a lower-bandwidth LTE link. The administrator wants real-time voice traffic to always use the fiber link, while bulk file transfers can use either link. Which configuration should be used?
Select an answer first
14application · medium
An organization wants to ensure that all traffic from branch users to the internet is inspected for threats, while traffic to the corporate data center over MPLS is not inspected to reduce latency. Which approach should the administrator take in Prisma SD-WAN?
Select an answer first
15foundation · easy
What is the first step in the initial configuration of Prisma SD-WAN when onboarding a new branch site?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to SD-WAN-ENGINEER

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Palo Alto Networks. “SD-WAN-ENGINEER” is a trademark of its owner, used for identification only.