Which environmental prerequisite must be confirmed before physically installing a FlexPod rack?

The Cisco UCS firmware has been upgraded to the latest version.

The rack is already populated with all compute, network, and storage components.

The rack has sufficient power and cooling capacity for the planned components.

The FlexPod management IP addresses have been assigned to all components.

Which of the following is a software prerequisite for a FlexPod installation?

A dedicated storage VLAN for management traffic

A fully populated rack with all components installed

Validated firmware and software versions for all components

A backup of the existing configuration on all components

Which of the following is an example of a post-upgrade validation check?

Verifying that all components report the expected firmware version

An administrator is configuring the initial setup of a NetApp storage system for a FlexPod. The administrator has set the cluster management IP and created the cluster. What is the next step in the initial configuration?

Configure the network interfaces for the cluster nodes.

Create the SVM (Storage Virtual Machine) for data access.

Add the storage controllers to the cluster.

Create aggregates from the physical disks.

Cisco and NetApp Certified FlexPod Implementation and Administration Specialist

Domain 4Objective 3

How to Install and Upgrade the FlexPod Solution CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST Practice Questions (Page 1)

Part of the FlexPod Administration domain, which makes up ~25% of our current practice bank.

26questions here

6free pages

6concepts

Questions 1–5

1foundation · easy
Which environmental prerequisite must be confirmed before physically installing a FlexPod rack?
Select an answer first
2foundation · easy
Which of the following is a software prerequisite for a FlexPod installation?
Select an answer first
3foundation · easy
Which of the following is an example of a post-upgrade validation check?
Select an answer first
4application · medium
An administrator is configuring the initial setup of a NetApp storage system for a FlexPod. The administrator has set the cluster management IP and created the cluster. What is the next step in the initial configuration?
Select an answer first
5foundation · easy
Which tool is commonly used to perform the initial configuration of a NetApp storage system?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by NetApp. “CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST” is a trademark of its owner, used for identification only.