Third-Party or Multicloud Integration JN0-637 Practice Questions (Page 2)

Questions 6–10

1. 6expert · hard

   A network administrator configured the SRX to send logs to a third-party SIEM via syslog over TLS. The SIEM is not receiving any logs. The administrator verifies that the SRX can reach the SIEM's IP address and that the security policy permits the traffic. What is the next step to troubleshoot this issue?

   • AConfirm that the SRX's time zone is set to UTC.
   • BEnsure that the SRX's hostname is resolvable by the SIEM.
   • CCheck if the SRX's system log severity level is set to 'info' or higher.
   • DVerify that the SRX's syslog server configuration includes the correct port and that the SIEM is listening on that port.
   Reveal Solution Discussion Select an answer first
2. 7expert · hard

   An organization is integrating its Juniper SRX with two public clouds. They have set up IPsec VPNs to both clouds and are using BGP to exchange routes. The security team wants to ensure that traffic from one cloud to the other is inspected by the SRX. After configuration, they find that traffic between the clouds is not being inspected. What is the most likely cause?

   • AThe SRX is not advertising the routes from one cloud to the other via BGP.
   • BThe IPsec VPNs are using different IKE versions.
   • CThe security policy on the SRX is configured to permit all traffic.
   • DThe SRX is configured with a single routing instance for both clouds.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   What is a typical configuration step when integrating a Juniper security device with a third-party SIEM?

   • AConfiguring the device to send syslog messages to the SIEM server.
   • BReplacing the device's operating system with the SIEM's OS.
   • CDisabling all security policies to allow SIEM traffic.
   • DInstalling the SIEM software on the Juniper device.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   A VPN tunnel to a cloud provider is not establishing. What is a common issue to check?

   • AMismatched pre-shared keys or IKE parameters between the Juniper device and the cloud VPN gateway.
   • BThe cloud provider's region has a different time zone.
   • CThe Juniper device's power supply is not redundant.
   • DThe cloud provider's logo is not visible.
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which scenario best describes a purpose of integrating a third-party SIEM with a Juniper security platform?

   • ATo centralize collection and analysis of security logs from the Juniper device.
   • BTo provide a redundant backup for the Juniper device's configuration.
   • CTo replace the Juniper device's firewall filtering engine.
   • DTo automatically create VPN tunnels between sites.
   Reveal Solution Discussion Select an answer first