Secure Wire JN0-637 Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which operational command would you use to verify the status of Secure Wire interfaces?

   • Ashow configuration interfaces
   • Bshow security secure-wire status
   • Cshow security policies
   • Dshow interfaces terse
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   What is the primary purpose of Secure Wire on Juniper security platforms?

   • ATo replace a firewall's routing table with a simple switching table for all traffic
   • BTo encrypt traffic between two remote sites over an untrusted network
   • CTo provide a dedicated management interface for out-of-band device administration
   • DTo provide a transparent, bump-in-the-wire security inspection point for traffic between two interfaces
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   Which security feature is NOT supported in a Secure Wire deployment?

   • AIntrusion prevention system (IPS) inspection
   • BApplication identification
   • CStateful firewall inspection
   • DIPsec VPN termination on the Secure Wire interfaces
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   Where would you look in the logs to find Secure Wire-related events?

   • AThe chassis log
   • BThe security log
   • CThe system log
   • DThe routing log
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   What is the effect of configuring the 'secure-wire' statement on an interface pair in Junos?

   • AIt enables VLAN tagging on the two interfaces
   • BIt enables transparent Layer 2 forwarding between the two interfaces
   • CIt enables IP routing between the two interfaces
   • DIt enables encryption of traffic between the two interfaces
   Reveal Solution Discussion Select an answer first