Deploy Campus Fabric Architectures JN0-460 Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   A company is deploying a campus fabric and wants to manage the switches through Mist AI. The switches are currently unconfigured and have no management IP address. What is the first step the administrator should take to onboard the switches to Mist AI?

   • AConnect the switches to the network and use ZTP to automatically onboard them to Mist.
   • BConfigure the switches with a static IP address and then use the Mist API to add them.
   • CUse the Mist mobile app to scan the switch QR code and onboard it.
   • DManually configure the management IP address on each switch and then add them to Mist.
   Reveal Solution Discussion Select an answer first
2. 7expert · hard

   A network engineer is troubleshooting a VXLAN connectivity issue in a campus fabric. A host on leaf-1 cannot communicate with a host on leaf-2. The engineer verifies that the underlay is healthy and that the VTEPs are up. The engineer also checks the EVPN routes on leaf-1 and sees that the MAC address of the remote host is present in the EVPN MAC table. However, the host still cannot communicate. What is the most likely cause of this issue?

   • AThe VXLAN VNI is not configured on leaf-2.
   • BThe EVPN route target is not configured on leaf-1.
   • CThe VXLAN tunnel between the VTEPs is not operational.
   • DThe underlay routing protocol is not redistributing the VTEP loopback routes.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   What is the purpose of micro-segmentation in a campus fabric?

   • ATo enforce security policies at a granular level, such as per-device or per-application.
   • BTo reduce the number of switches required in the fabric.
   • CTo replace the need for firewalls in the fabric.
   • DTo combine multiple VLANs into a single broadcast domain.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What is the primary benefit of integrating campus fabric switches with Mist AI?

   • AIt eliminates the need for any routing protocol in the fabric.
   • BIt provides a dedicated hardware controller for all fabric switches.
   • CIt provides cloud-based management, assurance, and automation for the fabric.
   • DIt enables direct Layer 2 connectivity between all switches without an IP underlay.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A network administrator is deploying 50 new leaf switches in a campus fabric. The switches are being shipped to remote sites and will be installed by local technicians who have limited networking expertise. The administrator wants to automate the initial configuration and ensure that the switches are automatically onboarded to Mist AI for management. Which approach should the administrator use?

   • APre-configure each switch manually at the central office before shipping.
   • BUse a configuration template in Mist to push the config after the switches are manually configured with an IP address.
   • CUse ZTP with DHCP to provide the switches with an initial configuration that points them to the Mist cloud.
   • DUse the Mist mobile app to configure each switch on-site via Bluetooth.
   Reveal Solution Discussion Select an answer first