Asset Visibility JN0-452 Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   In the Mist dashboard, where would you find a real-time map showing the current location of assets?

   • AUnder the 'WLAN' configuration page
   • BUnder the 'Network Insights' section
   • CUnder the 'Asset Visibility' section
   • DUnder the 'Alerts' page
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A hospital is deploying Mist asset tags on infusion pumps to locate them when nurses need them urgently. The pumps move frequently between patient rooms and storage closets. The facility has Mist APs mounted in every room and corridor. After deployment, the location accuracy in the storage closets is poor, showing pumps in adjacent rooms. What is the most likely cause and the appropriate fix?

   • AThe APs in the corridor are too powerful; reduce the transmit power of the corridor APs to prevent signal bleed into the closets.
   • BThe asset tags are using Wi-Fi instead of BLE; reconfigure the tags to use BLE for better indoor accuracy.
   • CThe asset tags have low battery; replace the batteries in all tags located in the storage closets.
   • DThe storage closets lack sufficient AP coverage for trilateration; add an AP or a BLE sensor in each closet.
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which two wireless technologies does Juniper Mist asset visibility use to track assets?

   • ANFC and RFID
   • BZigbee and LoRaWAN
   • CGPS and cellular
   • DBluetooth Low Energy (BLE) and Wi-Fi
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   How does Juniper Mist determine the location of a BLE asset tag?

   • ABy measuring the RSSI of the tag's signal at multiple access points and using trilateration
   • BBy reading the tag's MAC address and looking it up in a central database
   • CBy using the tag's cellular signal strength
   • DBy using GPS coordinates transmitted by the tag
   Reveal Solution Discussion Select an answer first
6. 15expert · hard

   A hospital has deployed Mist BLE tags on IV pumps. The pumps are used in patient rooms and stored in a central supply room. The staff reports that some pumps are not visible on the dashboard, while others show incorrect locations. The tags are new and have full batteries. What is the most likely cause of these combined issues?

   • AThe pumps are stored in metal cabinets in the supply room, blocking BLE signals.
   • BThe asset tags have been assigned to the wrong site in the Mist dashboard.
   • CThe APs in the patient rooms are not configured to listen for BLE advertisements.
   • DThe BLE tags are not compatible with the Mist APs.
   Reveal Solution Discussion Select an answer first