Source NAT JN0-232 Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   Which operational command is used to view active source NAT translations on a Junos device?

   • Ashow security nat destination
   • Bshow security nat pool
   • Cshow security nat source
   • Dshow security nat static
   Reveal Solution Discussion Select an answer first
2. 7expert · hard

   A company has a Junos device with two internet connections, each with a different public IP range. The primary connection uses 203.0.113.0/24 and the backup uses 198.51.100.0/24. The administrator wants to source NAT internal traffic using the primary connection's public IPs, but if the primary connection fails, the backup should be used. How should the source NAT be configured to support this failover?

   • AConfigure two source NAT rules: one for the primary connection and one for the backup, with the backup rule having a lower priority.
   • BConfigure a single source NAT rule with a pool containing only the backup public IP range.
   • CConfigure a single source NAT rule with a pool containing only the primary public IP range.
   • DConfigure a single source NAT rule with a pool containing both public IP ranges.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   What is the primary benefit of using port address translation (PAT) with source NAT?

   • AIt provides encryption for outbound traffic
   • BIt allows multiple internal hosts to share a single public IP address
   • CIt allows internal hosts to use private IP addresses without any translation
   • DIt increases the bandwidth available to internal hosts
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   Which two zones must be specified when configuring a source NAT rule on a Junos device?

   • ATrust zone and untrust zone
   • BManagement zone and security zone
   • CInternal zone and external zone
   • DSource zone and destination zone
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   What is the primary purpose of source NAT on a Junos device?

   • ATo filter traffic based on source IP address and port
   • BTo hide private source IP addresses behind a public address for outbound traffic
   • CTo translate the destination IP address of inbound traffic to an internal server
   • DTo encrypt traffic between two sites over the internet
   Reveal Solution Discussion Select an answer first