Which command would you use to configure a Junos device to send SNMP traps to a management station at 192.0.2.50?

set snmp trap-receiver 192.0.2.50

set system snmp trap-target 192.0.2.50

set snmp community public target 192.0.2.50

set snmp trap-group mygroup targets 192.0.2.50

What is the primary purpose of the Network Time Protocol (NTP) on network devices?

To prioritize time-sensitive network traffic

To encrypt management traffic between network devices

To provide a backup routing path in case of link failure

To synchronize the system clocks of network devices to a common time source

Juniper NetworksCertified Associate, Junos

Domain 4Objective 4

Monitoring and Logging JN0-105 Practice Questions (Page 3)

Part of the Configuration Basics domain, which makes up ~10% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~4–6 in this domain), expect 1–1 from this objective — we provide 19 practice questions to prepare you well beyond it. (estimate)

19questions here

4free pages

11concepts

Questions 11–15

11foundation · easy
Which command would you use to configure a Junos device to send SNMP traps to a management station at 192.0.2.50?
Select an answer first
12foundation · easy
Which Junos configuration statement controls how many archived versions of a syslog file are retained?
Select an answer first
13foundation · easy
What is the primary purpose of the Network Time Protocol (NTP) on network devices?
Select an answer first
14foundation · easy
Which syslog facility is typically used for messages generated by the kernel?
Select an answer first
15foundation · easy
Which Junos configuration hierarchy is used to configure syslog logging to a remote server?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-105

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-105” is a trademark of its owner, used for identification only.

Monitoring and Logging JN0-105 Practice Questions (Page 3)

Questions 11–15

Which command would you use to configure a Junos device to send SNMP traps to a management station at 192.0.2.50?

Which Junos configuration statement controls how many archived versions of a syslog file are retained?

What is the primary purpose of the Network Time Protocol (NTP) on network devices?

Which syslog facility is typically used for messages generated by the kernel?

Which Junos configuration hierarchy is used to configure syslog logging to a remote server?

Keep studying — Configuration Basics