Deploy FortiMail in Transparent Mode NSE6-FORTIMAIL-ADMINISTRATOR Practice Questions (Page 3)

Questions 11–13

1. 11application · medium

   A network engineer is deploying FortiMail in transparent mode and wants to ensure that the device can be managed remotely via SSH. The bridge interfaces are configured, but the management interface is not yet set. What is the correct way to configure management access?

   • AUse the mail server's IP address for management access.
   • BAssign an IP address to the bridge interface and enable SSH on that interface.
   • CCreate a separate VLAN interface with an IP address and enable SSH on that interface.
   • DEnable SSH on the external bridge interface only.
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A company is deploying FortiMail in transparent mode and needs to ensure that the device does not become a single point of failure. They have two FortiMail devices and want to provide redundancy. What is the recommended approach?

   • AConfigure the second device as a backup and manually switch over when needed.
   • BConfigure the two devices in an HA cluster using the bridge interfaces.
   • CPlace the two devices in parallel and use load balancing on the upstream router.
   • DUse only one device and rely on the mail server's redundancy.
   Reveal Solution Discussion Select an answer first
3. 13application · medium

   An administrator is troubleshooting why FortiMail in transparent mode is not applying content filtering to outgoing email. The mail flow is: internal clients → FortiMail → internet. What is the most likely reason FortiMail is not inspecting the outgoing messages?

   • AThe mail server is using implicit TLS, which FortiMail cannot decrypt.
   • BThe outgoing SMTP traffic is not being intercepted because the proxy is only enabled for incoming traffic.
   • CThe FortiMail device is not the default gateway for the internal clients.
   • DThe FortiMail bridge interfaces are configured in the wrong VLAN.
   Reveal Solution Discussion Select an answer first