Configure SD-WAN Members and Zones NSE5-SD-WAN-CORE-ADMINISTRATOR Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which interface type can be added as an SD-WAN member to provide a logical overlay connection?

   • AHardware switch interface
   • BManagement interface
   • CLoopback interface
   • DIPsec tunnel interface
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   What is the primary purpose of an SD-WAN zone in Fortinet SD-WAN?

   • ATo isolate management traffic from data traffic
   • BTo encrypt all traffic between branches
   • CTo provide a single IP address for all WAN interfaces
   • DTo group SD-WAN members for policy and routing decisions
   Reveal Solution Discussion Select an answer first
4. 3expert · hard

   A company has two sites, each with two WAN links. They want to use SD-WAN to provide redundancy and load balancing. They also want to ensure that if one link at a site fails, the other link can carry all traffic. What is the best way to configure the SD-WAN zones?

   • ACreate one zone for all links across both sites.
   • BUse policy-based routing to load balance between the links.
   • CCreate two zones per site, one for each link.
   • DCreate one zone per site, add both links to the zone, and configure SD-WAN rules for load balancing and failover.
   Reveal Solution Discussion Select an answer first
5. 4application · medium

   A retail chain has two internet circuits at each branch: a 500 Mbps fiber link and a 100 Mbps LTE backup. The SD-WAN administrator wants both to be usable for active traffic, with the fiber preferred for bulk transfers and the LTE used only when the fiber is down or congested. What is the correct way to configure this in the SD-WAN setup?

   • AAdd both physical interfaces as SD-WAN members in the same zone, then use SD-WAN rules to set the fiber as primary and LTE as secondary.
   • BConfigure the LTE as an overlay link and the fiber as an underlay link, then assign them to the same zone.
   • CAdd only the fiber interface as an SD-WAN member and configure the LTE as a static route in the routing table.
   • DCreate two separate zones, one for each link, and then apply a policy to route traffic between the zones.
   Reveal Solution Discussion Select an answer first
6. 5application · easy

   An administrator is configuring SD-WAN on a FortiGate and wants to add a physical interface (port4) and a VLAN interface (vlan100) to the same SD-WAN zone. What is the correct way to do this?

   • AAdd both port4 and vlan100 as SD-WAN members and assign them to the same zone.
   • BAdd both to the SD-WAN member list, but they must be in separate zones.
   • CAdd port4 as a member, but vlan100 must be added to a different zone.
   • DAdd vlan100 as a member, but port4 must be added to a different zone.
   Reveal Solution Discussion Select an answer first