Identify the Reason a Pool Member Has Been Marked Down by Health Monitors F5CAB5 Practice Questions (Page 2)

Questions 6–10

1. 6expert · hard

   A pool member is marked down. The monitor is an HTTP monitor. The administrator checks the monitor logs and sees that the monitor is failing with a 'Timeout' error. The administrator can access the application from a browser on the same network as the BIG-IP. What is the most likely cause of the timeout?

   • AThe monitor is checking for a specific content string that is not present in the response.
   • BThe monitor is not associated with the pool, so it is using default settings.
   • CThe monitor is configured with the wrong destination port.
   • DThe monitor's timeout is set too low for the application's response time.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   A health monitor has an interval of 5 seconds and a timeout of 3 seconds. If the monitor fails once, how long will it take for the BIG-IP to send the next health check?

   • A8 seconds after the failure
   • BImmediately after the failure
   • C5 seconds after the failure
   • D3 seconds after the failure
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   In an F5 BIG-IP health monitor, what does the 'interval' setting define?

   • AThe maximum time allowed for a health check to complete
   • BThe time between consecutive health checks
   • CThe time a member must be up before it is considered available
   • DThe number of consecutive failures before marking a member down
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A pool member is marked down. The administrator checks the monitor logs and sees that the monitor is failing with a 'Connection refused' error. The application service is running and listening on the correct port. What is the most likely cause of this issue?

   • AThe monitor is configured with the wrong destination port.
   • BThe monitor's timeout is set too low, causing it to give up before the connection is established.
   • CThe monitor is not associated with the pool, so it is using default settings.
   • DThe monitor is checking for a specific content string that is not present in the response.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A health monitor is configured with an interval of 10 seconds and a timeout of 5 seconds. The monitor starts failing at time T=0. Assuming the monitor fails on every attempt, at what approximate time will the pool member be marked down?

   • AAt T=25 seconds
   • BAt T=5 seconds
   • CAt T=15 seconds
   • DAt T=30 seconds
   Reveal Solution Discussion Select an answer first