Identify, Based on Traffic, Which VLAN/route/egress IP Would Be Used F5CAB2 Practice Questions (Page 4)

Questions 16–19

1. 16foundation · easy

   A BIG-IP route to 10.0.0.0/8 shows a 'dynamic' origin in the routing table. What does this status indicate about the route?

   • AThe route is automatically updated based on traffic patterns
   • BThe route was learned from a routing protocol
   • CThe route was manually configured by an administrator
   • DThe route is only used when the primary route fails
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   A BIG-IP selects a route that points to VLAN 300 via next-hop 10.0.3.1. The self-IP on VLAN 300 is 10.0.3.2/24. What source IP address will the BIG-IP use for outbound traffic on this VLAN?

   • AThe destination IP address of the packet
   • BThe management IP address
   • C10.0.3.2
   • D10.0.3.1
   Reveal Solution Discussion Select an answer first
4. 18expert · hard

   A BIG-IP has interface 1.1 with VLAN10 untagged and VLAN20 tagged. A frame arrives on 1.1 with no tag. The administrator expects the frame to be in VLAN10, but it is being dropped. What is the MOST likely cause?

   • AThe frame is tagged with VLAN 20
   • BVLAN10 is not enabled on the interface
   • CThe interface is in a trunk
   • DVLAN20 is the default VLAN
   Reveal Solution Discussion Select an answer first
5. 19foundation · easy

   An interface 1.4 is a member of VLAN 50. A packet arrives on interface 1.4 with an 802.1Q tag of 50. How does the BIG-IP handle this packet?

   • AIt forwards the packet to the management plane for inspection
   • BIt strips the tag and assigns the packet to the untagged VLAN
   • CIt associates the packet with VLAN 50 and processes it normally
   • DIt drops the packet because the tag is not needed on an access port
   Reveal Solution Discussion Select an answer first