U/A F5CAB1 Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   A BIG-IP module has a provisioning state of 'none'. What does this indicate about the module?

   • AThe module is provisioned with all available resources.
   • BThe module is provisioned with a minimal resource allocation.
   • CThe module is licensed but not provisioned.
   • DThe module is not provisioned and is not active for use.
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   An F5 administrator logs into the BIG-IP Configuration Utility and navigates to System > License. The page shows that the BIG-IP Access Policy Manager (APM) module is listed as licensed. However, when the administrator checks System > Resource Provisioning, APM is not listed at all. The administrator needs to configure an APM access policy immediately. What should the administrator do first?

   • AProvision APM with a nominal level in System > Resource Provisioning and reboot the BIG-IP system.
   • BCreate the APM access policy directly in the Configuration Utility; the license alone is sufficient to enable the module's features.
   • CRe-activate the license using the license key to ensure APM is properly registered before attempting configuration.
   • DUse tmsh to run 'modify sys provision apm level none' to activate the module without requiring a reboot.
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which command-line command displays the provisioning status of modules, including their configured resource levels?

   • Atmsh show sys provision
   • Btmsh list sys db
   • Ctmsh show sys hardware
   • Dtmsh show sys license
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   An F5 administrator is reviewing the provisioning states on a BIG-IP system and sees the following: 'ltm level nominal', 'apm level dedicated', 'asm level none'. The administrator needs to configure a security policy using ASM. What is the first step the administrator should take?

   • AConfigure the ASM security policy directly in the Configuration Utility.
   • BCheck the license to confirm ASM is licensed.
   • CReboot the system to automatically provision ASM.
   • DProvision ASM to a nominal level and reboot the system.
   Reveal Solution Discussion Select an answer first
6. 15expert · medium

   An F5 administrator is troubleshooting why the DNS Services module is not working on a BIG-IP system. The administrator runs 'tmsh show sys license' and sees DNS Services is listed. The administrator also runs 'tmsh list sys provision' and sees 'dns level none'. The system has been rebooted multiple times since the license was activated. What is the most likely reason DNS Services is not working?

   • ADNS Services was automatically disabled due to a system error.
   • BDNS Services is not compatible with the current BIG-IP version.
   • CDNS Services is licensed but has not been provisioned, so it is not active.
   • DDNS Services requires a separate license key that has not been activated.
   Reveal Solution Discussion Select an answer first