Objective 3.02 Identify Necessary Software Maintenance Procedures to Address a Given Condition 304 Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   An administrator suspects that APM access policy errors are occurring and needs to review the relevant log messages. Which BIG-IP WebUI facility should they use?

   • AAPM Access Policy
   • BDNS
   • CLogs
   • DStatistics
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   An administrator is about to upgrade a BIG-IP APM device. Which step must be performed before starting the upgrade to ensure the current configuration can be restored if the upgrade fails?

   • ATake a UCS backup
   • BDisable the APM virtual servers
   • CReboot the device into maintenance mode
   • DClear the APM session tables
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   A company has a three-device BIG-IP APM cluster. One device is being upgraded and reboots, causing it to leave the cluster temporarily. What is the expected behavior of the remaining two devices?

   • AThe remaining devices automatically re-sync their configuration to the upgraded device.
   • BThe remaining devices stop processing traffic until the upgraded device rejoins.
   • CThe remaining devices require a manual failover to continue operating.
   • DThe remaining devices continue to operate normally and maintain the cluster configuration.
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   What is the purpose of an OPSWAT integration in BIG-IP APM?

   • ATo provide endpoint posture assessment by checking for antivirus and other security software
   • BTo provide a web application firewall for APM virtual servers
   • CTo provide a VPN tunnel for remote access
   • DTo provide load balancing for APM servers
   Reveal Solution Discussion Select an answer first
6. 15expert · hard

   An administrator is upgrading the active device in a BIG-IP APM cluster. The upgrade causes the active device to reboot, and the standby device takes over. The standby device is running the previous version. After the upgrade, the administrator notices that the access policy on the standby device is not enforcing the latest changes that were made on the active device before the upgrade. What is the most likely reason?

   • AThe standby device automatically reverted to a default configuration.
   • BThe configuration changes were not synced to the standby before the upgrade.
   • CThe standby device requires a manual configuration reload after failover.
   • DThe upgrade on the active device corrupted the configuration on the standby.
   Reveal Solution Discussion Select an answer first