An administrator is configuring BIG-IP APM Network Access for a small office with 50 remote users. The internal network uses a 10.10.0.0/16 subnet. The administrator wants to ensure that all remote client traffic appears to come from a single, predictable IP address for logging and security purposes. Which SNAT configuration should be used?

SNAT Pool with a single BIG-IP self IP

SNAT Pool with multiple BIG-IP self IPs

In BIG-IP APM Network Access, what is the primary purpose of SNAT (Secure Network Address Translation) for remote client traffic?

To translate the source IP address of client packets to an address that is routable to the target network

To filter client traffic based on destination port and protocol

To authenticate remote clients before they can access the network

To encrypt the payload of client packets to ensure confidentiality across the network

Which SNAT configuration is typically used to enable Remote Desktop connections to network access clients in BIG-IP APM?

SNAT Pool with only the client's original IP address

No SNAT, because RDP is a connectionless protocol

SNAT Automap, which uses the BIG-IP's self IP as the source address

SNAT with a static NAT entry for each RDP client

What is the difference between SNAT Automap and a SNAT pool in BIG-IP APM Network Access?

Automap is faster than a SNAT pool

Automap requires a license, while a SNAT pool does not

Automap uses the BIG-IP's self IP, while a SNAT pool uses a list of addresses

Automap is used for UDP traffic, while a SNAT pool is used for TCP

For VoIP traffic through BIG-IP APM Network Access, why is SNAT often required?

To ensure that media and signaling packets have a routable source address for return traffic

To compress VoIP packets to reduce bandwidth usage

To encrypt VoIP signaling to prevent eavesdropping

To prioritize VoIP packets over other traffic using QoS policies

F5Certified Technology Specialist, BIG-IP APM

Domain 2Objective 4

Objective 2.04 Determine Appropriate SNAT Settings to Meet Access Requirements for Network Access (e.g., VoIP, Active Mode FTP, Remote Desktop to Network Access Clients) 304 Practice Questions (Page 1)

Part of the Section 2: Configure and deploy an access profile domain, which makes up ~56% of our current practice bank. F5 does not publish an official question count, but from its 90-minute exam (~35–60 total, ~20–34 in this domain), expect 1–1 from this objective — we provide 18 practice questions to prepare you well beyond it. (estimate)

18questions here

4free pages

7concepts

Questions 1–5

1application · medium
An administrator is configuring BIG-IP APM Network Access for a small office with 50 remote users. The internal network uses a 10.10.0.0/16 subnet. The administrator wants to ensure that all remote client traffic appears to come from a single, predictable IP address for logging and security purposes. Which SNAT configuration should be used?
Select an answer first
2foundation · easy
In BIG-IP APM Network Access, what is the primary purpose of SNAT (Secure Network Address Translation) for remote client traffic?
Select an answer first
3foundation · easy
Which SNAT configuration is typically used to enable Remote Desktop connections to network access clients in BIG-IP APM?
Select an answer first
4foundation · easy
What is the difference between SNAT Automap and a SNAT pool in BIG-IP APM Network Access?
Select an answer first
5foundation · easy
For VoIP traffic through BIG-IP APM Network Access, why is SNAT often required?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to 304

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by F5. “304” is a trademark of its owner, used for identification only.