Identify Node Discovery Options. VXRAIL-DESIGN Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   What is the purpose of validating discovered nodes in VxRail?

   • ATo configure the storage controllers
   • BTo verify that each node meets the requirements for deployment
   • CTo assign IP addresses to the nodes
   • DTo install the VxRail software on the nodes
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   What is a key advantage of using automated discovery over manual entry in VxRail?

   • AIt reduces the chance of human error when entering node details
   • BIt requires no network connectivity to the nodes
   • CIt works without any prerequisites
   • DIt automatically configures the cluster's networking
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   A VxRail administrator is deciding between manual and automated node discovery for a new cluster. The nodes are already racked, cabled, and powered on. The administrator has a complete list of iDRAC IPs and credentials. Which factor should most influence the choice of discovery method?

   • AManual discovery is faster when the node list is already available.
   • BAutomated discovery requires a vCenter Server to be deployed first.
   • CAutomated discovery is faster and reduces the chance of data entry errors.
   • DManual discovery is required when nodes are on the same subnet.
   Reveal Solution Discussion Select an answer first
5. 14expert · hard

   A VxRail administrator is troubleshooting automated discovery. The discovery tool finds all nodes, but one node shows a 'Validation Failed' status. The error message indicates that the node's iDRAC firmware is not supported. What is the most appropriate action?

   • AReboot the node and re-run discovery.
   • BRemove the node from the discovery results and add it manually.
   • CProceed with deployment, as the node was discovered successfully.
   • DUpdate the iDRAC firmware to a supported version and re-run discovery.
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   Which of the following is typically checked during node validation?

   • AThe node's power consumption
   • BThe node's physical location in the data center
   • CThe node's warranty status
   • DCompatibility of the node's hardware with VxRail
   Reveal Solution Discussion Select an answer first