Describe VxRail Rack Requirements VXRAIL-DEPLOY-V2 Practice Questions (Page 2)

Questions 6–9

1. 6expert · hard

   A VxRail rack is being installed in a data center with a raised floor that has a load rating of 750 kg per square meter. The rack weighs 1,800 kg and has a footprint of 0.6 m × 1.2 m. The facilities team is considering using a load-spreading plate that covers an area of 1.5 m². What is the resulting load per square meter with the plate?

   • A500 kg/m²
   • B750 kg/m²
   • C1,000 kg/m²
   • D1,200 kg/m²
   Reveal Solution Discussion Select an answer first
2. 7expert · hard

   A VxRail rack is being connected to the network. The rack has two 25GbE ports on each node. The network team wants to use link aggregation to increase bandwidth and provide redundancy. What is the recommended way to configure the uplinks?

   • AUse a single 50GbE port instead of two 25GbE ports.
   • BUse one port for data and the other for management.
   • CUse both ports as independent links and rely on the switch's spanning tree protocol.
   • DUse LACP to aggregate the two ports into a single logical link.
   Reveal Solution Discussion Select an answer first
4. 8expert · hard

   A VxRail rack is being deployed in a data center that has a cooling system with a capacity of 15 kW. The rack's power draw is 10 kW. The room also has other equipment that draws 4 kW. The facility manager wants to add another VxRail rack with a power draw of 10 kW. What is the most appropriate action?

   • AReduce the power draw of the existing equipment to compensate.
   • BInstall the second rack but only run it during off-peak hours.
   • CUpgrade the cooling system to at least 24 kW.
   • DInstall the second rack and rely on the existing cooling because the total load is only slightly above capacity.
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A VxRail rack is being connected to the network. The rack has two top-of-rack switches, and the network team wants to provide redundancy. What is the recommended way to connect the switches to the core network?

   • AConnect both switches to the same core switch using multiple uplinks.
   • BConnect each switch to a different core switch using multiple uplinks.
   • CConnect only one switch to the core network and use the other as a standby.
   • DConnect the switches in a daisy-chain to the core network.
   Reveal Solution Discussion Select an answer first