How is the VRRP master down timer typically calculated?

Two times the advertisement interval

Equal to the advertisement interval

Ten times the advertisement interval

Three times the advertisement interval plus skew time

Two OS10 switches are configured for VRRP with the same priority (100). The network team wants Switch A to be the master. What configuration change will ensure Switch A is elected master?

Assign a higher virtual IP to Switch A.

Decrease Switch B's advertisement interval.

Increase Switch A's priority to 110.

What is the primary purpose of VRRP in an OS10 data center network?

To encrypt traffic between switches in the same data center

To provide a redundant default gateway for hosts by allowing multiple routers to share a virtual IP address

To load-balance traffic across multiple equal-cost paths to the same destination

To filter traffic between VLANs using access control lists

Two OS10 switches run VRRP for a gateway. The network team needs failover to occur as quickly as possible when the master switch loses power, but they are concerned about unnecessary master flaps due to brief network hiccups. They decide to reduce the advertisement interval from 1 second to 200 milliseconds. What is the most important additional consideration for this change?

The master down timer will automatically adjust to 600 milliseconds, reducing failover time but increasing sensitivity to transient packet loss.

The virtual IP address must be changed to a different subnet to support the faster timer.

The priority of the backup switch must be increased to ensure it takes over faster.

Preemption must be disabled to prevent the original master from reclaiming the role after recovery.

Dell PowerSwitch Data Center Deploy

Domain 2Objective 3

Configure and Verify the Operation of VRRP in OS10 POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 2)

Part of the FHRP domain, which accounts for 10% of the POWERSWITCH-DATA-CENTER-DEPLOY exam.

17questions here

4free pages

5concepts

10%of the exam

Questions 6–10

6foundation · easy
How is the VRRP master down timer typically calculated?
Select an answer first
7application · easy
Two OS10 switches are configured for VRRP with the same priority (100). The network team wants Switch A to be the master. What configuration change will ensure Switch A is elected master?
Select an answer first
8foundation · easy
What is the primary purpose of VRRP in an OS10 data center network?
Select an answer first
9foundation · easy
What is the default VRRP priority in OS10?
Select an answer first
10application · medium
Two OS10 switches run VRRP for a gateway. The network team needs failover to occur as quickly as possible when the master switch loses power, but they are concerned about unnecessary master flaps due to brief network hiccups. They decide to reduce the advertisement interval from 1 second to 200 milliseconds. What is the most important additional consideration for this change?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWERSWITCH-DATA-CENTER-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSWITCH-DATA-CENTER-DEPLOY” is a trademark of its owner, used for identification only.

Configure and Verify the Operation of VRRP in OS10 POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 2)

Questions 6–10

How is the VRRP master down timer typically calculated?

Two OS10 switches are configured for VRRP with the same priority (100). The network team wants Switch A to be the master. What configuration change will ensure Switch A is elected master?

What is the primary purpose of VRRP in an OS10 data center network?

What is the default VRRP priority in OS10?

Keep studying — FHRP