Configure ESXi Host Access to PowerStore VMware Storage Resources POWERSTORE-OPERATE Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   For Fibre Channel connectivity between an ESXi host and PowerStore, what must be configured in the SAN fabric?

   • AZoning that includes the host's HBA WWPNs and the PowerStore FC port WWPNs.
   • BA DNS SRV record for the PowerStore FC ports.
   • CAn iSCSI target with the host's IQN listed.
   • DA VLAN that separates storage traffic from management traffic.
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   An ESXi host is connected to PowerStore via FC and has been properly zoned and defined in PowerStore. The host sees the LUN, but only one path is active. The administrator expects multiple paths for redundancy. What should the administrator check?

   • AVerify that the host's FC adapters are zoned to all PowerStore FC target ports that are in the same fabric.
   • BConfirm that the ESXi host has the PowerStore storage provider (VASA) installed.
   • CEnsure that the host's iSCSI software adapter is enabled and connected.
   • DCheck that the PowerStore volume is mapped to the host with the correct LUN ID.
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which ESXi CLI command can be used to verify that an ESXi host can see a PowerStore volume?

   • Aesxcli network ip connection list
   • Besxcli storage core device list
   • Cesxcli software vib list
   • Desxcli system syslog config get
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   When configuring an ESXi host to access PowerStore volumes over iSCSI, what must be defined on the PowerStore side to allow the host's initiator to connect?

   • AA VMkernel port on the ESXi host with the same IP address as the PowerStore iSCSI target.
   • BA host definition that includes the initiator's IQN and is associated with the appropriate volume(s).
   • CA Fibre Channel zone that includes the host's WWPNs and the PowerStore FC ports.
   • DA DNS record mapping the PowerStore iSCSI target to the ESXi host's hostname.
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   How does an ESXi host typically discover PowerStore storage resources when using iSCSI?

   • AThe host scans the Fibre Channel fabric for registered state change notifications (RSCN).
   • BThe host performs a Send Targets discovery to the PowerStore iSCSI target IP addresses.
   • CThe host queries the PowerStore REST API to list available volumes.
   • DThe host uses multicast to automatically find all PowerStore arrays on the network.
   Reveal Solution Discussion Select an answer first