Configure ESXi Host Access to PowerStore VMware Storage Resources. POWERSTORE-DEPLOY Practice Questions (Page 4)

Questions 16–20

1. 16application · medium

   An administrator has added an ESXi host to PowerStore and wants to map a volume to it. The host uses iSCSI and has been configured with the correct initiator IQN. However, when the administrator tries to map the volume, the host is not listed as an available host. What is the most likely cause?

   • AThe ESXi host is not running the correct version of vSphere.
   • BThe host is not in the same subnet as the PowerStore storage IPs.
   • CThe volume is already mapped to another host.
   • DThe host has not been discovered by PowerStore because the initiator IQN is not registered.
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   What is the purpose of mapping a PowerStore volume to an ESXi host?

   • ATo set the volume's LUN ID on the storage system
   • BTo allow the ESXi host to see and access the volume as a LUN
   • CTo enable replication of the volume to another PowerStore system
   • DTo assign a VMFS filesystem to the volume
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   Which of the following is required to map a PowerStore volume to an ESXi host?

   • AThe volume must be formatted with VMFS before mapping
   • BThe host must be defined in PowerStore with its initiators
   • CThe ESXi host must be in the same vCenter Server as the PowerStore system
   • DThe volume must be part of a volume group
   Reveal Solution Discussion Select an answer first
5. 19expert · hard

   An administrator has configured an ESXi host to connect to PowerStore over iSCSI. The host can see the PowerStore targets, but when attempting to map a volume to the host, the host is not listed in PowerStore. The host has been added to PowerStore, and the initiator IQN is correct. What is the most likely cause?

   • AThe host is not in the same subnet as the PowerStore storage IPs.
   • BThe host's iSCSI adapter is not enabled.
   • CThe volume is already mapped to another host.
   • DThe host object in PowerStore is not associated with the correct initiator.
   Reveal Solution Discussion Select an answer first
6. 20foundation · easy

   Which of the following is a prerequisite for an ESXi host to access PowerStore storage over iSCSI?

   • AThe PowerStore storage system must be in the same vCenter Server as the ESXi host
   • BA Fibre Channel HBA with a supported firmware version
   • CA software iSCSI adapter enabled and configured on the ESXi host
   • DA dedicated physical NIC for each VMkernel port used for storage
   Reveal Solution Discussion Select an answer first