Explain Gatekeeper Management. POWERMAX-OPERATE Practice Questions (Page 5)

Questions 21–24

1. 21application · medium

   An administrator is troubleshooting why a Solutions Enabler host cannot see a newly added PowerMax array. The administrator has verified that the HBA is zoned and the array is visible in `symcfg list`. However, `symcfg list -gatekeeper` does not show any gatekeepers. What should the administrator check next?

   • AThe array's firmware version
   • BThe masking view to ensure gatekeeper devices are presented to the host
   • CThe host's multipathing software
   • DThe Solutions Enabler daemon status
   Reveal Solution Discussion Select an answer first
2. 22application · medium

   A company is deploying Solutions Enabler on a new Windows server to manage a PowerMax array. The administrator wants to ensure that the gatekeeper devices are automatically discovered and configured. What is the recommended way to allocate gatekeepers to this host?

   • AManually create a masking view that includes the host's WWNs and a set of gatekeeper devices
   • BUse the symmask command to add gatekeeper devices to the host's HBA
   • CInstall the Solutions Enabler software and it will automatically create gatekeeper devices on the array
   • DUse the symconfigure command to add gatekeeper devices to the host's storage group
   Reveal Solution Discussion Select an answer first
4. 23application · medium

   A company has a PowerMax array and wants to add a new host to manage it. The administrator has created a masking view that includes the host's WWNs and a set of gatekeeper devices. However, the host still cannot communicate with the array. What is a likely reason for this issue?

   • AThe gatekeeper devices are too small
   • BThe host's HBA is not zoned to the array's front-end ports
   • CThe gatekeeper devices are not in the same storage group as the data LUNs
   • DThe Solutions Enabler version is too old
   Reveal Solution Discussion Select an answer first
5. 24foundation · easy

   A Solutions Enabler host cannot communicate with the PowerMax array. The symcfg discover command fails. What is a common cause of this issue?

   • AThe host's operating system is not supported by Solutions Enabler
   • BThe array's cache is full
   • CThe gatekeeper devices are not properly presented to the host
   • DThe host's IP address is not in the array's access list
   Reveal Solution Discussion Select an answer first