Demonstrate the Use of Simplified Symmwin Scripts and Tools to Perform a PowerMax 2000 and 8000 Upgrade POWERMAX-INSTALL Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   An administrator is running a Simplified Symmwin script to upgrade a PowerMax 2000. The script outputs a warning message but continues to run. What should the administrator do?

   • AIgnore the warning and proceed to the next script.
   • BContact Dell support before continuing.
   • CLet the script continue and review the warning in the log file after it completes.
   • DImmediately terminate the script to prevent any issues.
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   Which statement best describes the scope of Simplified Symmwin scripts in a PowerMax upgrade?

   • AThey are used only for post-upgrade verification and health checks.
   • BThey cover the entire upgrade process from pre-checks to post-upgrade verification.
   • CThey are limited to firmware updates only, excluding software and configuration changes.
   • DThey are designed for a single specific upgrade step and cannot be reused.
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which of the following is a typical check performed by post-upgrade verification scripts?

   • AVerifying the number of connected hosts.
   • BVerifying that all directors and modules are online.
   • CVerifying the color of the status LEDs.
   • DVerifying the physical location of the array.
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   What does the output of a Simplified Symmwin script typically indicate?

   • AThe progress and status of the upgrade step being executed.
   • BThe serial number of the array.
   • CThe IP address of the PowerMax system.
   • DThe names of all connected hosts.
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   After completing a PowerMax 8000 upgrade, an administrator runs a Simplified Symmwin post-upgrade verification script. The script reports that all checks passed, but the administrator notices that the array's performance seems slower than before. What should the administrator do?

   • AReboot the array to clear any temporary issues.
   • BRerun the verification script to confirm the results.
   • CRun additional performance monitoring tools to determine if the slowdown is related to the upgrade.
   • DContact Dell support to report a potential issue.
   Reveal Solution Discussion Select an answer first