Perform SRDF Operations Using Unisphere for PowerMax. POWERMAX-DESIGN-V2 Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   A team is setting up SRDF between two PowerMax arrays. They have multiple RDF directors available. They need to create an SRDF group that will be used for a high-priority application. What is the most important consideration when selecting the RDF directors and ports for this group?

   • AChoose directors and ports that are physically connected to the corresponding directors on the remote array.
   • BSelect the directors with the highest port numbers to ensure they are the fastest.
   • CSelect directors that are not used by any other SRDF group to avoid contention.
   • DUse the same director for both local and remote to simplify management.
   Reveal Solution Discussion Select an answer first
2. 12foundation · medium

   In Unisphere for PowerMax, which of the following can be monitored for an SRDF pair?

   • APair state
   • BNumber of users logged in
   • CFirmware version of the switch
   • DCPU temperature of the array
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   A storage administrator notices that SRDF replication performance has degraded. They need to identify whether the issue is due to link congestion or a problem with a specific pair. In Unisphere for PowerMax, which monitoring view should they use to see both link health and per-pair transfer rates?

   • AThe Alert log, which lists all SRDF errors and warnings.
   • BThe Job history, which records completed SRDF operations.
   • CThe Device list, which shows the state of each SRDF pair.
   • DThe SRDF dashboard, which shows link status and per-pair data transfer rates.
   Reveal Solution Discussion Select an answer first
5. 14foundation · medium

   When creating an SRDF group in Unisphere for PowerMax, which of the following must be specified?

   • ARDF directors and ports
   • BSRDF consistency group name
   • CFailover mode (automatic or manual)
   • DSource and target device names
   Reveal Solution Discussion Select an answer first
6. 15expert · hard

   After a failover, production is running at the DR site. The original source site is now ready, but the SRDF pairs are in a suspended state. The administrator needs to fail back to the original source. What is the correct sequence of operations?

   • AEstablish the pairs in the reverse direction, then perform a failback.
   • BDelete the pairs and re-create them with the original source as the target.
   • CResume the pairs, then fail back.
   • DFail back immediately; the system will handle resynchronization.
   Reveal Solution Discussion Select an answer first