Install and Upgrade Solutions Enabler on Unix, Linux, and Windows Hosts. POWERMAX-DESIGN-V2 Practice Questions (Page 4)

Questions 16–20

1. 16application · medium

   After upgrading Solutions Enabler on a Linux host, an administrator wants to verify that the upgrade was successful and that the host can still communicate with the PowerMax array. Which command should the administrator run first?

   • A`symcli -v` to check the version and `symcfg list` to verify connectivity to the array.
   • B`symcfg -v` to check the version and `symcfg connect` to test connectivity.
   • C`symcli -version` and `symcfg -list` to check the version and array connectivity.
   • D`storapid -v` to check the daemon version and `symcfg discover` to refresh the array list.
   Reveal Solution Discussion Select an answer first
2. 17expert · hard

   A company is running Solutions Enabler 9.2 on a Linux host and wants to upgrade to 9.4. The host also runs a custom script that parses the output of `symcfg list` and depends on the exact formatting of the output. The administrator has verified that the upgrade path from 9.2 to 9.4 is supported. What is the most important consideration before performing the upgrade?

   • AEnsure the host has at least 16 GB of RAM to support the new version.
   • BReview the release notes for any changes to command output formatting that could break the custom script.
   • CUpgrade the PowerMax array firmware first to ensure compatibility.
   • DBack up the Solutions Enabler configuration files to a separate location.
   Reveal Solution Discussion Select an answer first
4. 18application · medium

   An administrator is upgrading Solutions Enabler on a Linux host from version 9.0 to 9.2. The upgrade is complete, but the administrator wants to ensure that the daemon is running the new version. Which command should the administrator use?

   • A`ps -ef | grep storapid` to check the daemon process.
   • B`symcfg list` to verify the daemon is communicating with the array.
   • C`symcli -v` to check the Solutions Enabler version.
   • D`storapid -version` to check the daemon version.
   Reveal Solution Discussion Select an answer first
5. 19expert · hard

   A Linux administrator installed Solutions Enabler, but `symcfg list` fails with a 'Permission denied' error. The administrator verifies that the `storapid` daemon is running and the user is a member of the `symapi` group. What is the most likely cause of the permission error?

   • AThe daemon is running under a different user than the CLI.
   • BThe user does not have read permission on the Solutions Enabler configuration files.
   • CThe host's firewall is blocking the connection to the daemon.
   • DThe `SYMCLI_OFFLINE` environment variable is set to `TRUE`.
   Reveal Solution Discussion Select an answer first
6. 20foundation · medium

   After installing Solutions Enabler on a Linux host, which command is used to start the Solutions Enabler daemon (storapid) and enable the host to communicate with Dell PowerMax storage systems?

   • Asymcfg discover
   • Bstorapid start
   • Cstordaemon start storapid
   • Dsymcli start
   Reveal Solution Discussion Select an answer first