Reconfigure Meta Data Managers POWERFLEX-OPERATE Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   A PowerFlex cluster has five MDMs: one primary, one secondary, and three standbys. The administrator needs to remove one standby MDM for hardware refresh. The cluster is healthy and all MDMs are in sync. What is the correct procedure?

   • AAdd a new MDM before removing the standby to maintain the count.
   • BRemove the standby MDM using the appropriate PowerFlex command.
   • CFirst promote the standby to secondary, then remove it.
   • DRemove the primary MDM first, then the standby.
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   When planning an MDM reconfiguration, which factor is most important to consider for maintaining cluster fault tolerance?

   • AThe storage capacity of the MDM nodes
   • BThe network bandwidth between MDMs and SDS nodes
   • CThe number of SDC clients connected to the cluster
   • DThe number of MDMs and their ability to form a quorum
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   What is a critical step to perform after adding a new MDM to the cluster?

   • AChange the MDM password
   • BReinstall the PowerFlex software on all nodes
   • CReboot all SDS nodes
   • DVerify that the new MDM is synchronized and healthy
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   Which PowerFlex CLI command is used to remove an MDM from the cluster?

   • Ascli --remove_mdm
   • Bscli --unregister_mdm
   • Cscli --drop_mdm
   • Dscli --delete_mdm
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   When inspecting the MDM cluster topology, which role indicates an MDM that is ready to take over if the primary or secondary fails?

   • ASecondary
   • BStandby
   • CPrimary
   • DManager
   Reveal Solution Discussion Select an answer first