An administrator needs to update firmware on a PowerEdge XE server that is not connected to the corporate network. The server is accessible only through a direct console connection. Which update method is most appropriate?

Use Dell Repository Manager to update the firmware.

Run the DUP from the host OS using a local file.

Use Lifecycle Controller with a local DUP on a USB drive.

Use iDRAC to update the firmware over the network.

After a firmware update, the server's iDRAC and BIOS versions are correct, but the RAID controller firmware is still the old version. The update job reported success. What is the most likely cause?

The RAID controller firmware update requires a separate reboot.

The RAID controller firmware was rolled back automatically.

The RAID controller is not supported by the update method.

The RAID controller update was not included in the update job.

An administrator needs to update firmware on a Dell PowerEdge XE server remotely using a web-based interface. Which method should they use?

Dell Update Package (DUP) via command line

An administrator is updating firmware on a PowerEdge XE server using Lifecycle Controller. The update job completes with a status of 'Failed' for the BIOS update, but the iDRAC update succeeded. What should the administrator do?

Review the Lifecycle Controller logs to identify the cause of the BIOS update failure.

Roll back the iDRAC update to match the BIOS version.

Re-run the BIOS update job immediately.

Reboot the server and check if the BIOS update was applied.

A firmware update job on a PowerEdge XE server fails during the BIOS update, and the server now fails to POST. The administrator suspects the update was interrupted. What is the most appropriate recovery action?

Power off the server and reseat the BIOS chip.

Use the iDRAC to roll back to the previous BIOS version.

Re-run the BIOS update job from Lifecycle Controller.

Contact Dell support for a replacement motherboard.

Dell PowerEdge XE Operate

Domain 3Objective 3

Perform Firmware Updates POWEREDGE-XE-OPERATE Practice Questions (Page 1)

Part of the Firmware Management domain, which accounts for 14% of the POWEREDGE-XE-OPERATE exam.

26questions here

6free pages

5concepts

14%of the exam

Questions 1–5

1expert · hard
An administrator needs to update firmware on a PowerEdge XE server that is not connected to the corporate network. The server is accessible only through a direct console connection. Which update method is most appropriate?
Select an answer first
2expert · hard
After a firmware update, the server's iDRAC and BIOS versions are correct, but the RAID controller firmware is still the old version. The update job reported success. What is the most likely cause?
Select an answer first
3foundation · easy
An administrator needs to update firmware on a Dell PowerEdge XE server remotely using a web-based interface. Which method should they use?
Select an answer first
4expert · hard
An administrator is updating firmware on a PowerEdge XE server using Lifecycle Controller. The update job completes with a status of 'Failed' for the BIOS update, but the iDRAC update succeeded. What should the administrator do?
Select an answer first
5expert · hard
A firmware update job on a PowerEdge XE server fails during the BIOS update, and the server now fails to POST. The administrator suspects the update was interrupted. What is the most appropriate recovery action?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWEREDGE-XE-OPERATE

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-XE-OPERATE” is a trademark of its owner, used for identification only.