A network administrator is troubleshooting a Dell switch that is not forwarding traffic on a specific port. The port is up, but the LED is amber. What is the most likely cause?

The port is configured with a VLAN that does not exist.

The port is configured as a trunk port.

The port is in a blocking state due to Spanning Tree Protocol.

The port is configured with a speed mismatch.

A network administrator is troubleshooting a Dell switch that is experiencing high CPU utilization. The administrator notices that the switch is receiving a large number of broadcast packets. What is the most likely cause?

The switch is configured with too many VLANs.

The switch is configured with a low spanning-tree priority.

A broadcast storm caused by a loop in the network.

The switch is configured with a large MAC address table.

A network administrator is troubleshooting a Dell switch that is not passing traffic between two VLANs. The switch has SVIs for both VLANs, and they are up/up. The administrator confirms that IP routing is enabled. What is the most likely cause?

The switch is not configured with a default gateway.

The SVIs are in different VRFs.

The SVIs are not assigned IP addresses.

A Dell switch is configured with a link aggregation group (LAG) to a server. The server team reports that the LAG is not providing the expected bandwidth. The switch shows that all LAG members are up and in the LAG. What is the most likely cause?

The LAG is configured with a low port priority.

The LAG is configured with a high LACP rate.

The load-balancing algorithm is set to 'src-dst-mac'.

The server's NIC teaming is set to 'fault tolerance'.

Dell Networking Design

Domain 6Objective 2

Identify Common Troubleshooting Issues. NETWORKING-DESIGN Practice Questions (Page 2)

Part of the Deployment Support domain, which accounts for 9% of the NETWORKING-DESIGN exam.

9questions here

2free pages

1concept

9%of the exam

Questions 6–9

6application · medium
A network administrator is troubleshooting a Dell switch that is not forwarding traffic on a specific port. The port is up, but the LED is amber. What is the most likely cause?
Select an answer first
7application · medium
A network administrator is troubleshooting a Dell switch that is experiencing high CPU utilization. The administrator notices that the switch is receiving a large number of broadcast packets. What is the most likely cause?
Select an answer first
8expert · hard
A network administrator is troubleshooting a Dell switch that is not passing traffic between two VLANs. The switch has SVIs for both VLANs, and they are up/up. The administrator confirms that IP routing is enabled. What is the most likely cause?
Select an answer first
9expert · hard
A Dell switch is configured with a link aggregation group (LAG) to a server. The server team reports that the LAG is not providing the expected bandwidth. The switch shows that all LAG members are up and in the LAG. What is the most likely cause?
Select an answer first

Finished these 4 questions?

Review the revealed explanations, or continue through the curriculum.

No more pagesBack to NETWORKING-DESIGN

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “NETWORKING-DESIGN” is a trademark of its owner, used for identification only.