List and Explain the Process for Creating Extent and Device Mobility Jobs Using Unisphere METRO-NODE-OPERATE Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   In Unisphere for Dell Metro Node, what is the first step in creating an extent mobility job?

   • ASelect the source device and immediately start the job
   • BTake the source device offline to prepare for migration
   • CNavigate to the Mobility Jobs page and select 'Create Extent Mobility Job'
   • DDelete the target device to make room for the new data
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   In which scenario would an administrator most likely use an extent mobility job?

   • ATo migrate an entire virtual volume to a new Metro Node cluster for hardware refresh
   • BTo move a frequently accessed portion of a volume to a higher-performance storage tier
   • CTo create a point-in-time snapshot of a volume for backup purposes
   • DTo configure synchronous replication between two Metro Node clusters
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   An administrator is creating an extent mobility job in Unisphere to move an extent from volume A to volume B. After selecting the source volume and the extent, the administrator must specify the target volume and the destination offset. What is the purpose of specifying the destination offset?

   • AIt determines the exact location on the target volume where the extent will be placed.
   • BIt defines the size of the extent to be moved.
   • CIt sets the priority of the mobility job relative to other jobs.
   • DIt specifies the number of retries if the job fails.
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   Which condition must be met before creating an extent or device mobility job in Dell Metro Node?

   • AThe source device must be taken offline before the job starts
   • BThe Metro Node cluster must be in a degraded state
   • CThe source and target devices must be in the same Metro Node cluster
   • DThe target device must have less capacity than the source device
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   A storage administrator is creating a device mobility job in Unisphere to move a device from one storage array to another. After selecting the source device, what is the next step in the wizard?

   • ASet the job priority and schedule.
   • BSpecify the target storage array and the target volume.
   • CConfirm the source device is offline.
   • DSelect the extents to move within the device.
   Reveal Solution Discussion Select an answer first