List and Describe the Steps to Complete Distributed Devices on a Metro Node Using VPlexcli METRO-NODE-OPERATE Practice Questions (Page 2)

Questions 6–10

1. 6expert · hard

   An administrator is creating a distributed device and receives an error: 'Error: Cannot create distributed device. The specified storage volumes are not in the same consistency group.' The volumes are on different arrays. What is the most likely cause and solution?

   • AThe administrator must create the distributed device from the cluster where both volumes are visible.
   • BThe volumes must be in the same consistency group on both arrays; the administrator should add them to a common consistency group.
   • CThe administrator must use the '--force' flag to bypass the consistency group check.
   • DThe volumes are on different arrays, which is not supported; the administrator should use volumes from the same array.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   An administrator is connected to a Metro Node via VPlexcli and wants to view the properties of a distributed device named 'dd1'. They are currently in the /clusters/cluster-1 context. What should they do first?

   • ARun 'distributed-device show --name dd1' directly from the current context.
   • BRun 'cd storage-elements' then 'distributed-device show --name dd1'.
   • CRun 'cd devices' to navigate to the devices context, then run 'distributed-device show --name dd1'.
   • DRun 'device show --name dd1' from the current context.
   Reveal Solution Discussion Select an answer first
4. 8expert · hard

   An administrator creates a distributed device and then runs 'distributed-device show --name dd1'. The output shows that the device is in a 'degraded' state. What is the most likely cause?

   • AThe administrator is viewing the device from the wrong cluster.
   • BThe device is not yet fully initialized.
   • COne of the storage volumes on a cluster is offline or has failed.
   • DThe device was created with the wrong name.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   Which piece of information is required before creating a distributed device using VPlexcli?

   • AThe IP address of the storage array's service processor.
   • BThe firmware version of the storage array.
   • CThe serial number of the Metro Node hardware.
   • DThe name of the cluster where the distributed device will be created.
   Reveal Solution Discussion Select an answer first
6. 10expert · hard

   An administrator is creating a distributed device and receives an error: 'Error: The storage volume is already in use by another device.' The volume is not listed as being used by any device in the VPlexcli. What is the most likely cause?

   • AThe administrator is using the wrong volume name.
   • BThe volume is not visible to the cluster.
   • CThe volume is part of a consistency group that is already associated with a device.
   • DThe volume is on a different array than expected.
   Reveal Solution Discussion Select an answer first