Which IP addressing practice is recommended for ECS node interfaces to ensure stable network identity and easier troubleshooting?

Using the same IP for all interfaces

Using DHCP with short lease times

Using private IP addresses only for management

Using static or reserved IP addresses

A gaming company is deploying ECS for game asset storage. The workload is mixed: frequent small reads (for game assets) and occasional large writes (for updates). The company has a 10 GbE network and needs to minimize latency for reads while maintaining throughput for writes. Which network design best meets these conflicting requirements?

Use separate VLANs for read and write traffic, with standard MTU for reads and jumbo frames for writes.

Use a single VLAN with jumbo frames for all traffic.

Use jumbo frames on all interfaces and rely on QoS to prioritize reads.

Use standard MTU on all interfaces to minimize latency for reads.

Dell ECS Design

Domain 2Objective 1

Design an ECS Networking Solution to Meet Requirements or Use Cases ECS-DESIGN Practice Questions (Page 5)

Part of the ECS Solution Design Networking domain, which accounts for 20% of the ECS-DESIGN exam.

33questions here

7free pages

10concepts

20%of the exam

Questions 21–25

21foundation · easy
In an ECS network architecture, which component is used to segment broadcast domains and can be configured to separate management and data traffic?
Select an answer first
22foundation · easy
Which IP addressing practice is recommended for ECS node interfaces to ensure stable network identity and easier troubleshooting?
Select an answer first
23expert · hard
A gaming company is deploying ECS for game asset storage. The workload is mixed: frequent small reads (for game assets) and occasional large writes (for updates). The company has a 10 GbE network and needs to minimize latency for reads while maintaining throughput for writes. Which network design best meets these conflicting requirements?
Select an answer first
24foundation · easy
Which network security measure is used to control traffic based on source and destination IP addresses and ports?
Select an answer first
25foundation · easy
When troubleshooting a network issue in an ECS environment, which command is commonly used to test connectivity between two IP addresses?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to ECS-DESIGN

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “ECS-DESIGN” is a trademark of its owner, used for identification only.

Design an ECS Networking Solution to Meet Requirements or Use Cases ECS-DESIGN Practice Questions (Page 5)

Questions 21–25

In an ECS network architecture, which component is used to segment broadcast domains and can be configured to separate management and data traffic?

Which IP addressing practice is recommended for ECS node interfaces to ensure stable network identity and easier troubleshooting?

Which network security measure is used to control traffic based on source and destination IP addresses and ports?

When troubleshooting a network issue in an ECS environment, which command is commonly used to test connectivity between two IP addresses?

Keep studying — ECS Solution Design Networking