Configure and Perform Backups and Restores AVAMAR-OPERATE Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   An administrator needs to restore a specific email from an Exchange Server backup. The backup was taken as an image-level backup of the Exchange Server. What should the administrator use to perform this restore?

   • AMount the backup as a virtual disk and copy the email.
   • BPerform a granular restore of the Exchange database to extract the email.
   • CRestore the entire Exchange Server image and then extract the email.
   • DUse file-level restore to restore the email from the backup.
   Reveal Solution Discussion Select an answer first
2. 12expert · hard

   A backup administrator is monitoring a scheduled backup that is running slower than usual. The backup is for a large database client. The administrator suspects network congestion is causing the slowdown. What should the administrator do to confirm this?

   • ACheck the backup logs for network-related errors or warnings.
   • BCheck the client's disk space to see if it is full.
   • CCancel the backup and restart it immediately.
   • DIncrease the backup priority to speed up the backup.
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   A backup administrator is troubleshooting a failed backup for a Windows client. The Avamar Administrator shows the error 'Client connection lost' during the backup. The client is reachable via ping. What is the most likely cause of this issue?

   • AThe backup schedule is misconfigured.
   • BThe client's IP address has changed.
   • CThe Avamar Client service is not running on the client.
   • DThe Avamar server is out of storage space.
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   Where in the Avamar Administrator can an operator view the progress and status of currently running backups?

   • AClient Manager
   • BPolicy Manager
   • CActivity Monitor
   • DServer Manager
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   An administrator needs to restore a file from a backup to a new client that has never been backed up. The new client is already registered in Avamar. What should the administrator do?

   • ARestore the file to the original client and then copy it to the new client.
   • BSelect the file from the original client's backup and choose the new client as the restore destination.
   • CPerform a backup of the new client first, then restore the file.
   • DUse the Avamar Virtual Appliance to restore the file to the new client.
   Reveal Solution Discussion Select an answer first