CCIE Security
Domain 1Objective 8
1.8 Clustering and High Availability Features on Cisco ASA and Cisco FTD CCIE-SECURITY Practice Questions (Page 7)
Part of the 1.0 Perimeter Security and Intrusion Prevention domain, which accounts for 20% of the CCIE-SECURITY exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~10–16 in this domain), expect 1–1 from this objective — we provide 38 practice questions to prepare you well beyond it. (estimate)
38questions here
8free pages
11concepts
20%of the exam
Questions 31–35
- 31
A company is forming an ASA cluster using four ASA 5525-X appliances. They have configured the control link and data interfaces, but the cluster fails to form. The error log shows that the cluster control link is not coming up. Which prerequisite is most likely missing?
Select an answer first - 32
An engineer is configuring a new ASA cluster in routed mode. They have set up the control link and data interfaces. They want to ensure that traffic from the same source IP is consistently handled by the same cluster member to avoid asymmetric routing. Which configuration step is essential?
Select an answer first - 33
A network administrator is monitoring an ASA cluster and notices that some connections are being forwarded to a member that does not own the connection. They want to verify that the cluster is correctly forwarding packets to the owner. Which command should they use to check the connection ownership and forwarding behavior?
Select an answer first - 34
A company has two ASA 5516-X appliances configured in active/standby failover. They want to ensure that if the primary unit loses connectivity on its outside interface, the standby unit takes over. They have configured the failover link and interface monitoring. However, a test shows that failover does not occur when the outside interface is shut down. What is the most likely cause?
Select an answer first - 35
An organization is implementing active/active failover on a pair of ASA appliances in multiple-context mode. They have two security contexts: CONTEXT-A and CONTEXT-B. They want each appliance to be active for one context and standby for the other. What must they configure to achieve this?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “CCIE-SECURITY” is a trademark of its owner, used for identification only.