2.1 Design Scalable Meraki Auto VPN Architectures 500-220 Practice Questions (Page 6)

Questions 26–30

1. 26expert · hard

   A company is deploying Auto VPN with two hubs in different cloud regions. The primary hub is in us-east-1 and the secondary hub is in eu-west-1. Remote sites are distributed globally. The architect wants to minimize latency for the majority of sites while maintaining failover capability. Which placement strategy is most appropriate?

   • AUse only the us-east-1 hub and add a third hub in Asia
   • BAssign all sites to eu-west-1 as primary and us-east-1 as secondary
   • CAssign all sites to us-east-1 as primary and eu-west-1 as secondary
   • DAssign each site to the geographically closest hub as its primary, and the other hub as its secondary
   Reveal Solution Discussion Select an answer first
2. 27application · medium

   A logistics company is deploying Auto VPN across 25 warehouses. Each warehouse was previously configured with the 192.168.1.0/24 subnet for its local LAN. The network architect is planning the VPN design. What must be done to ensure proper routing across the Auto VPN?

   • AEnable VLAN tagging on each warehouse switch to separate the subnets
   • BRe-address each warehouse with a unique, non-overlapping subnet
   • CKeep the 192.168.1.0/24 subnet at each site and rely on NAT for inter-site traffic
   • DConfigure each warehouse MX with a static route to the other sites
   Reveal Solution Discussion Select an answer first
4. 28foundation · easy

   Which factor is most likely to limit the total number of VPN peers in a Meraki Auto VPN deployment?

   • AThe number of subnets configured on each MX
   • BThe VPN throughput and tunnel capacity of the MX appliances
   • CThe number of internet uplinks on each MX
   • DThe Meraki dashboard's ability to display the topology
   Reveal Solution Discussion Select an answer first
5. 29application · medium

   A multi-national company uses Auto VPN with a hub in each region. The network team wants to ensure that voice traffic between a branch and the regional hub uses the highest-quality WAN link, while bulk file transfers can use a lower-cost link. Which Meraki feature should be configured to achieve this?

   • AVLAN tagging for voice and data
   • BStatic routing to prefer one uplink for all traffic
   • CSD-WAN traffic shaping rules
   • DAuto VPN hub selection per application
   Reveal Solution Discussion Select an answer first
6. 30foundation · easy

   Where should VPN concentrators be placed to optimize performance and redundancy in a Meraki Auto VPN design?

   • AAt central locations with high-bandwidth internet connections and redundant power
   • BAt the smallest branch sites to minimize cost
   • CAt sites with the most users, regardless of bandwidth
   • DAt sites with the least amount of inter-site traffic
   Reveal Solution Discussion Select an answer first