CiscoCertified Network Professional Service Provider
Domain 5Objective 9
5.9 Configure and Verify NETCONF and RESTCONF 350-501 Practice Questions (Page 3)
Part of the Automation and Assurance domain, which accounts for 15% of the 350-501 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~8–12 in this domain), expect 1–1 from this objective — we provide 29 practice questions to prepare you well beyond it. (estimate)
29questions here
6free pages
10concepts
15%of the exam
Questions 11–15
- 11
An engineer is using a NETCONF client to push a new BGP configuration to a router. The client sends an edit-config operation, but the device returns an 'operation-not-supported' error. The engineer has verified that the NETCONF session is active and the target datastore is correct. What is the most likely cause of this error?
Select an answer first - 12
In a YANG module, which statement is used to define a simple leaf node that holds a single value of a specific type?
Select an answer first - 13
When a RESTCONF request fails due to a malformed JSON payload, which HTTP status code is typically returned?
Select an answer first - 14
A network engineer is automating the configuration of a new PE router. The engineer wants to stage a set of interface changes in a separate configuration buffer, validate them, and then apply them to the active configuration. The device supports the candidate datastore. Which NETCONF operation sequence should the engineer use?
Select an answer first - 15
A NETCONF client is unable to establish a session with the device. Which of the following is the most likely cause?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “350-501” is a trademark of its owner, used for identification only.